Connecting Dvd-Vcr To The Tv Using The Coaxial Cable; Connecting Dvd-Vcr To The Tv Using The Rca Cable; Connecting Dvd-Vcr To A Satellite Receiber Or Other Equipment - Samsung DVD-V18000 Instruction Manual

Connecting DVD-VCR to the TV using the Coaxial Cable

To receive television programmes a signal must be received from
one of the following sources:
GB
2
1
2
TV
3
4
4
3
5

Connecting DVD-VCR to the TV using the RCA Cable

TV
3
RF coaxial cable
You can connect your DVD-VCR to the television using the RCA cable if the appropriate input is available on
the television. You thus:
Obtain better quality sound and pictures
Simplify the setting up procedure of your DVD-VCR
Regardless of the type of connection chosen, you must always connect the coaxial cable supplied.
Otherwise, no picture will be visible on the screen when the DVD-VCR is switched off.
Make sure that both the television and the DVD-VCR are switched off before connecting the cables.
1
Connect the coaxial cable as indicated in the above section.
2 Connect one end of the RCA Audio/Video cable to the Video output and Audio L, R output socket on the rear of
the DVD-VCR.
3
Plug the other end into the appropriate connector on the television.
12
An outdoor aerial
An indoor aerial
A cable television network
A satellite receiver
Make sure that both the television and the DVD-VCR are
switched off before connecting the cables.
Remove the aerial or network input cable from the television.
Connect this cable to the 75 coaxial socket marked on the
rear of your DVD-VCR.
Plug the coaxial cable supplied into the TV socket on your
DVD-VCR.
Plug the other end of the coaxial cable into the connector
previously used for the aerial on the television.
To obtain better quality pictures and sound on your television, you
can also connect your DVD-VCR to the television via the RCA
cable (see section below) if your television is equipped with this
type of connection.
Aerial
2
Connecting DVD-VCR to a Satellite Receiver or Other Equipment
You can connect other audio and/or video equipment to your DVD-VCR in different ways. The following
illustrations give a few examples of the connection possibilities.
The RCA input/output connectors on the rear of the DVD-VCR are used for equipment,
such as camcorders, VCRs or sound systems.
REAR OF THE DVD-VCR
GB
Camcorder
VCR
Sound system
13