Table of Contents
Advertisement
Tuning Your Television for the DVD-VCR
GB
STANDBY/ON
OPEN/CLOSE
2
4
14
You must tune your television for the DVD-VCR only if you are
not using a RCA cable
➢
To view pictures from your DVD-VCR when a RCA
cable is used, the television must be set to the
audio/video mode (AV).
1
Switch on the television.
2
Switch on the DVD-VCR by pressing STANDBY/ON on the front
of the DVD-VCR or STANDBY/ON on the remote control.
3
Select a programme position on the television to be reserved for
use with your DVD-VCR.
4
Insert the video cassette in the DVD-VCR. Check that the
DVD-VCR starts reading the cassette; if not, press
5
Start a scan on your television or set the television to UHF
channel 38.
6
Fine tune the television until the pictures and sound are obtained
clearly.
7
If you cannot find the pictures and sound, or there is interference
from nearby channels, it may be necessary to change the setting
of the DVD-VCR output channel (see Setting the DVD-VCR
Output Channel on page 23 and Problems and Solutions on
page 67).
8
When the picture and sound are perfectly clear, store this
channel at the desired programme position on the television.
Result:
That programme is now reserved for use with your
DVD-VCR.
Deck Control Keys
The DVD-VCR uses one set of controls to operate both decks.
The following keys are helpful in successfully controlling each
deck.
1
STANDBY/ON Button
Press the STANDBY/ON button on the remote control or front
panel to turn on the DVD-VCR.
2
DVD Button
Press the DVD button on the remote control when you want to
control the DVD deck.
N
The DVD indicator will light on the Front Panel Display to
show that the DVD deck is selected.
3
VCR Button
Press the VCR button on remote control when you want to
❿ II
button.
control the VCR deck.
N
The VCR indicator will light on the Front Panel Display to
show that VHS deck is selected.
4
INPUT SEL. BUTTON
Press the INPUT SEL. button repeatedly to cycle through all of
your input sources, including the Tuner (PR##), Line 1 (rear AV
input), and Line 2 (front AV input).
• Input select is only available when the VCR deck is selected.
➢
Before using the VCR operation of 19~45 pages, press
the VCR button on the remote control to select VCR
mode.
Before using the DVD operation of 46~65 pages, press
the DVD button on the remote control to select and
watch DVD.
GB
STANDBY/ON
1
1
2
3
4
15
Advertisement
Table of Contents
