Connecting The Sbg1000 To The Cable System - Motorola SBG1000 User Manual

Overview Installation Troubleshooting Contact

Connecting the SBG1000 to the Cable System

Allow 5 to 30 minutes the first time you turn on the SBG1000 to find and lock on the appropriate communications
channels.
1
Be sure the computer is on and the SBG1000 is unplugged.
2
Connect one end of the coaxial cable to the cable outlet or splitter.
3
Connect the other end of the coaxial cable to the cable connector on the SBG1000.
Hand-tighten the connectors to avoid damaging them.
4
If you are using the optional Motorola External Diversity Antenna, install it now. Follow the instructions in
"Installing the Optional External Diversity Antenna"
5
Insert the Motorola SBG1000 Wireless Cable Modem Gateway CD-ROM into the CD-ROM drive.
6
Plug the power cord into the power connector on the SBG1000.
7
Plug the power cord into the electrical outlet. This turns the Motorola SBG1000 Wireless Cable Modem
Gateway on. You do not need to unplug it when not in use.
8
Check that the lights on the
•
Power icon turns on when AC power is connected to the SBG1000 and indicates that the power supply is
working properly
•
RX (receive) light flashes while scanning for the receive channel and changes to solid green when the
receive channel is locked.
•
TX (transmit) light flashes while scanning for the send channel and changes to solid green when the
send channel is locked.
•
LNK (link) light flashes during SBG1000 registration and configuration and changes to solid green when
the cable modem wireless gateway is registered.
•
Globe icon flashes when the SBG1000 is transmitting or receiving data.
Connecting the SBG1000 to the cable system
Home Print
Configuration: Basic Gateway TCP/IP Wireless Print Server USB
Front Panel cycle through this sequence:
.
X
22
Exit
FAQ Specifications Glossary License
on page 28.
1
2
SBG1000 Wireless Cable Modem Gateway User Guide
3
4