Dtmf Calls; Manual Dialling; Storing Dtmf Numbers; Dialling Stored Dtmf Numbers - Kenwood TK-7150 Instruction Manual

Note: To make DTMF calls, you must have an optional microphone with a DTMF keypad.
M D
ANUAL IALLING
Press and hold the PTT switch, then enter the digits on the microphone keypad.
• You can enter the digits 0 ~ 9,
• If programmed by your dealer, you do not need to continuously hold the PTT switch;
the transceiver will remain in the transmit state momentarily after releasing each key.
The length of time it remains in the transmit state is programmed by your dealer.
• While transmitting DTMF tones, the microphone is muted.
• To "store and send" a number, enter the digits then press the PTT switch to transmit.
S DTMF N
TORING UMBERS
If Auto Dialling has been activated by your dealer, you can store DTMF numbers
(16 digits maximum) in each of the 32 Auto Dial memory locations (01 ~ 32).
1 Press and hold the microphone # key for 1 second.
• "D" appears on the display.
2 Enter the desired digits on the microphone keypad.
• You can enter the digits 0 ~ 9,
press the PTT switch. To enter A, B, C, or D, press the PTT switch and enter 2, 5,
8, or 0 respectively.
• To cancel, press the
switch.
3 Press the microphone # key.
• "D–" appears on the display.
4 Enter a memory location number (01 ~ 32).
D S DTMF N
IALLING TORED
1 Press and hold the microphone
• "A" appears on the display.
2 Enter the desired memory location number (01 ~ 32).
3 Press the PTT switch to make the call.
12

DTMF CALLS

, and #.
, and #. When entering
key or any key on the transceiver front panel, other than the
UMBERS
key for 1 second.
or #, you must first