Conventional Zones; Transmitting; Receiving; 2-Tone Signalling - Kenwood TK-7150 Instruction Manual

T
RANSMITTING
1 Select the desired conventional zone and a channel.
• Make sure the channel is not in use. When a channel is in use, the BUSY (green)
LED will light.
2 Press and hold the PTT switch, then speak into the microphone in your
normal speaking voice.
• For best sound quality at the receiving station, hold the microphone approximately
1.5 inches (3 ~ 4 cm) from your mouth.
3 Release the PTT switch to receive.
4 When your conversation is finished, return the microphone to its hanger.
R
ECEIVING
1 Select the desired zone and channel.
2 When you hear a call, readjust the volume as necessary.
2-T S
ONE IGNALLING
2-Tone Signalling only opens the squelch when the transceiver receives two
tones corresponding to those set up in the transceiver. When the squelch opens,
you will be able to hear the caller without any further action.
• When the squelch opens, the CALL icon flashes.
After a correct 2-Tone signal is received and the squelch opens, pressing the key
programmed as Monitor will cancel the connection.
If your dealer programmed Transpond for 2-Tone Signalling, the transceiver
automatically sends an acknowledgment signal to the station that called you after
receiving the 2-Tone signal.
If your dealer has programmed Tone Alert for 2-Tone Signalling, the transceiver
will emit a beep when the correct 2-Tone signal is received.
To transmit a 2-Tone signal:
1 While pressing the PTT switch, press the key programmed as 2-Tone
Encode.
2 Continue to transmit as normal.
10

CONVENTIONAL ZONES