Preparation For Use - Kenwood XD-V555 Instruction Manual

PREPARATION FOR USE

•
Unplug the AC power cord from the AC socket before connecting or disconnecting any component.
Speakers (XD-V858, XD-V757, XD-V555)
Right speaker
Red
Black
Speaker connection
Connect each speaker wire to the SPEAKERS terminals as shown. Use speakers with an impedance of
6 Ω or more, as lower impedance speakers can damage the unit.
Connect the black wire to the minus (-) terminal, and the red wire to the plus (+) terminal.
Caution :
• Do not mix the right channel and left channel wiring when connecting the speakers to the unit.
The right speaker is the one on the right side when you are facing the front of the unit.
• Do not let bare speaker wires touch each other as this may damage the amplifier and/or speakers.
• Do not allow any objects to fall into or to be placed in the bass reflex ducts.
• Do not stand or sit on the speakers. If the speakers fall or collapse, you may be injured.
System Name
XD-V858
XD-V757
XD-V555
XD-V252
8 EN
Left speaker
Red
Black
Speaker Model
Name
LS-N90VS
LS-N70VS
LS-N50VS
LS-N30VS
Speakers (XD-V252)
Right speaker
Red
Black
CAUTION
Be sure to adhere to the following, or proper
ventilation will be blocked causing damage or
fire hazard.
÷ Do not place any objects impairing heat
radiation onto the top of unit.
÷ Leave a space around the unit (from the largest
outside dimension including projection) equal
or greater than, shown below.
Top panel : 50 cm
Side panel : 10 cm
Back panel : 10 cm
Left speaker
Red
Black