Table of Contents
Advertisement
Using the CD/MP3-CD/WMA-CD/USB device
Preparation
Loading a disc
1
Press CD/USB (CD/USB) button to select CD
mode.
2
Press (0) button to open the CD tray.
3
Place a disc into the tray with the label facing
up.
4
Press (0) button to close the CD tray.
For a CD, the total playtime and total number of
tracks will appear in the display.
For an MP3-CD and WMA-CD, the total album
number and total fi le number will appear on the
display.
⁄
• To remove the disc, press (0) button, grasp the disc by its
edges, and carefully pull it out.
Inserting a USB device
1
Press the
button to select standby mode.
2
Insert a USB device to the USB connector on the
front panel.
3
Press CD/USB (CD/USB) button to select USB
mode.
⁄
• To ensure good system performance; wait until the unit
completely reads the disc/USB device before proceeding.
• If the disc compartment is not loaded with a disc, "NO DISC" is
displayed. If the disc is unreadable, "ERR DISC" is displayed.
• If the disc is unreadable or there is no playable audio fi le in
the USB device, "NO DATA" is displayed.
• For audio fi les, reading time may exceed 10 seconds due
to the large number of songs compiled into one disc/USB
device.
• For audio fi les, "A" on the display represents ALBUM.
• For audio fi les, the total album number on the display
indicates the number of all the albums recorded in the disc/
USB device.
• The icon "MP3" appears only when an MP3-fi le is played.
The icon "WMA" appears only when an WMA-fi le is played.
• Insert or remove the USB device while in the standby mode.
Sound may be interrupted when inserting or removing the
USB device. This may occur even when the sound is not
played or recorded from/to the USB device.
When playing or recording from/to the USB device, removing
it or turning the power off may corrupt the sound source and
get it unplayable.
Playing a disc/USB device
Press FWD PLAY 6 (6) button to start playback.
The track/fi le number and elapsed playing time of
the current track/fi le appear on the display.
⁄
• To interrupt playback, press FWD PLAY 6 (6) button.
The playing time starts fl ashing.
To resume playback, press FWD PLAY 6 (6) button
again.
• To stop playback, press STOP 7 (7 stop) button.
Selecting a desired track/passage
To select a desired track
Press SEARCH/TUNING 4 or ¢ (4 or ¢
search +/–) button repeatedly until the desired
track appears on the display.
⁄
• If playback is stopped, press FWD PLAY 6 (6) button to
start playback.
• The digit buttons, 0–9 on the remote control unit can also be
used to select a track.
Press the digit buttons as shown below:
To select track 2 : 2 and ENTER
To select track 23 : 2, 3 and ENTER
To select track 120 (Audio fi le only) : 1, 2 and 0
To search for a particular passage during
playback
Press and hold SEARCH/TUNING 4 or ¢ (4 or
¢ search +/–) button for more than 3 seconds.
Press the FWD PLAY 6 (6) button when the
desired passage is located.
11
EN
Advertisement
Table of Contents
