My Powertouch Iii Is Not Responding; My Powertouch Iii Is Beeping. What Does That Mean; Powertouch Iii Does Not "Learn" New Commands Or Functions - Kenwood Sovereign VR-5900 User Manual

PowerTouch III

My PowerTouch III is not responding.

• Make sure you are within the operating range for PowerTouch III. See
"How is PowerTouch III Powered ?" on page 5 of this manual.
• Replace the batteries. See Chapter Two of the Connections and Setup
Guide.
• If you're using an IR receiver, make sure it is connected properly and
turned on. See Chapter Four of the Connections and Setup Guide.
• Check the contrast of the PowerTouch III's screen is adjusted prop-
erly. See "How Do I See PowerTouch III's Screen More Clearly?" on
page 74.
• If you want to use PowerTouch III by setting the control mode to
Zone B, make sure that the Multi-Zone function is On. If this func-
tion is Off, you cannot control Zone B from PowerTouch III.

My PowerTouch III is beeping. What does that mean?

The following table includes information about PowerTouch III beeps:
Number Tone
1 high
1 low
2 high
2 low

PowerTouch III does not "learn" new commands or functions.

• Check that the distance between PowerTouch III and the device's re-
mote is properly set. Do not place the devices remote right against
PowerTouch III.
• Check whether the PowerTouch III is too close to the receiver, a TV,
high-frequency fluorescent lighting or other electrical appliance.
• "Learning" may be not carried out with some devices' remote.
Meaning
Confirms your most recent button push or
touch
Indicates that your most recent button
push or touch could not be performed
Confirms learning or copying
Indicates that learning or copying was not
successful
103