Basic Operation
Adjusting the speaker balance (BALANCE)
To move
toward Left
Muting audio temporarily (MUTE)
Switching the display brightness (DIMMER)
The display brightness can be switched in 3 steps.
Enhancing the audio quality (SOURCE DIRECT)
The audio from the CD or an external source component can be reproduced in highest possible quality by bypassing the tone adjust-
ment circuitry (bass and treble).
16
EN
To move
toward Right
BALANCE
Enter the selection
Press within 8 sec.
L - - - -
Balance level display
÷ Press the BALANCE key shortly to display the current speaker
balance. (Begin the balance adjustment within 8 seconds after
the display starts.)
÷ During headphones listening, the speaker balance adjustment
is defeated.
Each press switches the selection.
1 [MUTE] indicator ON: The muting function is ON.
C D
T 0 6
2 [MUTE] indicator OFF: The muting function is OFF (can-
celed).
÷ The previous volume resumes when muting is canceled.
÷ Muting is also canceled when the volume is adjusted.
Each press switches the selection.
1 The brightness drops.
C D
T 0 6
2 The brightness drops further.
C D
T 0 6
3 Dimmer function is OFF (canceled).
C D
T 0 6
Each press switches the selection.
1 [CD] or [SOURCE] indicator ON: The Source Direct function
is ON.
2 [CD] or [SOURCE DIRECT] indicator OFF: The Source Direct
function is OFF (canceled).
÷ Do not switch the Source Direct function ON or OFF in the
middle of recording.
÷ When the SOURCE DIRECT function is ON, the tone adjustment
using the BASS and TREBLE keys is defeated.
- - - - - R
2 : 1 4
2 : 1 4
2 : 1 4
2 : 1 4
ON when the [CD] input is
selected
ON when an input source
other than [CD] is selected