Using The Cd; Loading A Disc; Playing A Cd; Selecting A Desired Track/Passage - Kenwood HM-337 Instruction Manual

Using the CD

Loading a disc

1 Press CD button to select CD mode.
2 Press push open button to open the CD door.
3 Place a CD into the tray with the label facing
up.
4 Close the CD door.
The total playtime and total number of tracks
will appear in the display.
5 To remove the CD, press push open button,
grasp the CD by its edges, and carefully pull it
out.
Notes:
• To ensure good system performance; wait until the
unit completely reads the disc before proceeding.
• If the CD compartment is not loaded with a CD or
the CD is unreadable, the message "NO DISC" will
be shown.

Playing a CD

1 Press 6 PLAY/PAUSE button to start
playback.
The track number and elapsed playing time of
the current track appear on the display.
To interrupt playback, press 6 PLAY/PAUSE
button.
The playing time will start flashing.
To resume playback press 6 PLAY/PAUSE
button again.
2 To stop playback, press 7 STOP button.

Selecting a desired track/passage

To select a desired track
Press 4 or ¢ button (4 or ¢ SEARCH/
TUNING button on the remote control) repeatedly
until the desired track appears on the display.
• If playback is stopped, press 6 PLAY/PAUSE
button to start playback.
To search for a particular passage during
playback
Press and hold 4 or ¢ button (4 or ¢
SEARCH/TUNING button on the remote control)
and released it when the desired passage is
located for CD.

Programming tracks

Programming tracks of a disc is possible when
playback is stopped. Up to 60 tracks can be stored
in the memory in any order.
1 In stop mode, press program button on the
unit (PROGRAM button on the remote control)
to enter program setting.
The icon "PROGRAM" and "– – P–01" will
appear on the display. "– –" indicates track
number of the CD and "P–01" indicates
program number.
2 Press 4 or ¢ button (4 or ¢ SEARCH/
TUNING button on the remote control) to
select the desired track.
The icon "PROGRAM" and program number will
start flashing.
3 Press program button on the unit ( PROGRAM
button on the remote control) to store the
selected track.
4 Repeat steps 2 and 3 to select and store other
desired tracks in this way.
The icon "PROGRAM" will appear on the display
and "FULL" will start flashing if you attempt to
program more than 60 tracks.
Press program button on the unit ( PROGRAM
button on the remote control) in stop mode to
review the program sequence.
5 Press 6 PLAY/PAUSE button to play the
programmed tracks.
continued to next page
9
EN