Table of Contents
Advertisement
When an error code ("E" and 4 digits) is displayed in other
cases, always turn the player off then on again.
If the error code does not disappear after this, press the
POWER button while holding the 7 on the player depressed.
When the display shows "INIT OK!", turn the player on again.
If the error code still remains in the display, note the error
code and consult your dealer or local KENWOOD for
servicing.
The display shows "LOCKED" and no operation is accepted.
¶ When the display shows "LOCKED" and the player cannot
be set to the standby mode or the disc tray cannot be opened,
perform the following procedure.
1. Set the mode switch of the joystick remote to the Orange
position.
2. While holding
7
The COMPONENT VIDEO OUTPUT jacks of the player do not
output video signals.
¶ When "RGB" is set in the "SCART Output Select" setting,
the COMPONENT VIDEO OUTPUT jacks of the player
do not output video signals.
90
Connection and Setup Guide 9
7
on the joystick remote, press the
P.AUDIO
AUDIO
button on the player main unit.
Connection and Setup Guide °
Symptoms and Treatment
DVF-R9030
Advertisement
Table of Contents
