Connecting Wires To Terminals - Kenwood KRC-369 Instruction Manual

Connecting Wires to Terminals

If no connections are made, do not let the wire come out from the tab.
5 When using the optional power amplifier,
connect to its power control terminal.
7 Depending on what antenna you are using,
connect either to the control terminal of the
motor antenna, or to the power terminal for
the booster amplifier of the film-type antenna.
Do not let the wire come
out from the tab.
Ignition key
switch10
Car fuse box
(Main fuse)
11
+
Battery
2 KENWOOD disc changer control input
To connect the Disc changer,
consult your Disc changer
manual.
P.CONT
ANT.
CONT.
Not Used 19
4b
ACC 13
Car fuse
box 14
Ground wire (Black) · (To car chassis)
–
12
Rear left output (White)
3
Fuse (10A)
24
Wiring harness
(Accessory1)25
4
Power control wire (Blue/White) 15
Motor antenna control wire (Blue)
17
ILLUMI
TEL MUTE
Ignition wire (Red) 20
Battery wire (Yellow) 21
22
— 17 —
23
Front left output (White)
(KRC-569 only)
FM/AM antenna input
Front right output (Red)
(KRC-569 only) 27
Rear right output (Red) 28
29
White/Black
FRONT • L
White
31
32
Gray/Black
FRONT • R
Gray
34
35
Green/Black
REAR • L
Green
37
38
Purple/Black
REAR • R
Purple
40
26
1
To front left
speaker 30
To front right
speaker 33
To rear left
speaker 36
To rear right
speaker 39