Mode - Kenwood KDV-5241U Instruction Manual

* If "Off" is selected in step
adjust the subwoofer phase.
C
Hi Pass (Hi Pass Filter)
Turn the control dial to select the cutoff
frequency to the front/rear speakers. Set this
to match the LPF setting.
• Off: All signals are sent to the front/rear
speakers.
• 62Hz: Frequencies lower than 62 Hz are
cut off.
• 95Hz: Frequencies lower than 95 Hz are
cut off.
• 135Hz: Frequencies lower than 135 Hz are
cut off.
D
VolAdjust, [–5 to +5]
Turn the control dial to adjust the input level
of each source (except FM).
Adjust to match the input level of the FM
sound level.
• Before making an adjustment, select the
source you want to adjust.
E
Loudness, [Off or On]
Turn the control dial to select "Off" or
"On". When "On" is selected, low and high
frequencies sound are boosted to produce a
well-balanced sound at low volume level.
4
Exit from the setting.
Storing your own sound modes
You can adjust the sound modes and store your own
adjustments in memory.
• When is shown on the display, you can
move back to the previous screen by pressing number
button 6.
1
2
Select a sound mode.
2
, you can only 3
Select a frequency range to adjust.
4
Adjust the sound elements of the selected
frequency range.
4
1
Press /
frequency band, then press
enhanced level for the selected frequency
band. [–6 to +6]
2
Press number button 5 (
the control dial to select the frequency.
3
Press number button 5 (
the control dial to select the quality slope (Q).
5
Repeat steps 3 and 4 to adjust the other
frequency bands.
6
Store the adjustments.
Preset value setting for each sound mode
Sound

mode

USER 0
ROCK +3
CLASSIC +2
POPS 0
HIP HOP +4
JAZZ +3
¢
to select the
5 ∞
/ to
), then turn
), then turn
Preset value
0 0 0
+2 0 +1
+2 0 +1
+1 0 +1
+1 –2 0
+2 +1 +2
English | 35
0
+1
0
+2
+1
+2