Selecting A Preset Sound - Kenwood KDV-5241U Instruction Manual

Selecting a preset sound mode
You can select a preset sound mode suitable to the music genre (iEQ: intelligent equalizer).
1
2
3
4
Adjusting the sound
You can adjust the sound characteristics to your
preference.
• When is shown on the display, you can
move back to the previous screen by pressing number
button 3 or 6.
1
2
• For "EQ" setting, see above.
3
Adjust the selected setting item.
A
Fad/Bal (Fader/Balance)
1
Press number button 1 (
to move to the "Fad/Bal" adjustment
display.
2
Adjust the speaker output balance by
pressing:
5 ∞
/ : between the front and rear
speakers. [F6 to R6]
34 | KDV-5241U
Enter the setting menu.
Select "EQ".
Select "On".
• If "Bypass" is selected, you can listen to the original
sound mode recorded.
display.
Select a preset sound mode.
B
Subwoofer
1
2
3
4
)
lights up on the
4 ¢
/ : between the left and
right speakers. [L6 to R6]
Press number button 1 (
move to the "Subwoofer" adjustment
display.
4 ¢
Use / to select a cutoff
frequency to the subwoofer.
• Off *: All signals are sent to the
subwoofer.
• 55Hz: Frequencies higher than 55 Hz
are cut off.
• 85Hz: Frequencies higher than 85 Hz
are cut off.
• 120Hz: Frequencies higher than 120 Hz
are cut off.
Turn the control dial to adjust the
subwoofer output level. [0 to 8]
Press number button 1 (
move to another setting level.
4 ¢
/ : select the quality of
LPF. [–12dB/oct or –24dB/oct]
Control dial: Turn the control dial to select
the subwoofer phase. [0deg (normal) or
180deg (reverse)]
Continued on the next page
) to
) to