Disarming Without A 2-Way Remote - Clifford Matrix 2.2X Owner's Manual

Car alarms

Hide thumbs Also See for Matrix 2.2X:

Table of Contents

notes: The first press of the remote button, while the

remote is beeping, only clears the alarm page (no com-

mand is sent to the vehicle).

The transceiver transmits immediately upon system trig-

ger and does not allow disarm during the first 6 seconds

after trigger.

The 2-way remote will respond with a number of beeps

and LED flashes according to whether a pinswitch, sen-

sor, activated the alarm (and also if NPC is active).

disarming without a 2-way remote

This feature allows you to disarm the security system without the 2-

way remote should it be lost, damaged, or disabled. In order to dis-

arm the system without a 2-way remote, you must have the vehicle's

ignition key and know where the Valet

to check with the installer for the location and the number of presses

of the Valet

button required to disarm the system.

To disarm the security system,

turn the ignition to the ON posi-

tion. Press the Valet

preset number of times (one to

five times) within 15 seconds. After five seconds the system will

disarm. If the system does not disarm, you may have waited too long;

turn the ignition Off and On and try again.

Location of Valet

Number of Pulses______________________________________

button the

Button_________________________________

button is located. Be sure

DRW-35

Table of Contents