Panic Mode; Valet ® Mode - Clifford Matrix 2.2X Owner's Manual

Car alarms

Hide thumbs Also See for Matrix 2.2X:

Table of Contents

panic mode

If you are threatened in or near your vehicle, you can attract

attention by triggering the system with your 2-way remote. Just

press

for two seconds, and you will enter Panic Mode. The

siren will sound and the parking lights will flash for the

programmed siren duration. To stop Panic Mode at any time,

press

on the 2-way remote again.

The remote responds with one flash of the Red LED upon

entering Panic Mode and two flashes of the Red LED upon

exiting Panic Mode.

valet

mode

You can prevent your security system from automatically arming

and triggering by using Valet

washing the vehicle or having it serviced. In Valet

security system will not arm, even with the 2-way remote, but all

convenience functions (door locks, trunk release, etc.) will

continue to work normally.

To enter or exit Valet

1. Turn the ignition on.

2. Turn the ignition off.

3. Press and release the Valet

The in-vehicle status LED will light solidly if you are entering

Valet

Mode, and it will go out if you are exiting Valet

The remote will respond with 3 Orange LED flashes on entering

and 2 beeps and 3 Orange LED flashes on exiting Valet

Mode. This is very useful when

Mode:

button once within 10 seconds.

Mode, the

DRW-35

Mode.

Table of Contents