High Security Disarm; Disarming Without A Transmitter - Clifford 3105X Owner's Manual

High Security Disarm

High Security Disarm makes it possible to silence and reset the system
when it is triggering, without disarming. If the system is triggered, and
the siren sounds for longer than six seconds, pressing
trigger and returns the system to an armed state. The system
does not disarm, but rather reset. This prevents you from disabling the
system should you want to disarm without visually checking the vehi-
cle. Pressing
Pressing
disarms the system immediately. The six second timer is provided for
your convenience, in case you accidentally trigger the system.

Disarming without a transmitter

This feature allows you to disarm the security system without the remote
transmitter should it be lost, damaged, or disabled. In order to disarm
the system without a remote transmitter, you must have the vehicle's
ignition key and know where the Valet button is located. Be sure to
check with the installer for the location and the number of presses of
the Valet button required to disarm the system.
To disarm the security system:
1. Turn the ignition to the ON position.
2. Press and release the Valet button the preset number of times
(one, the factory setting, to five times) within 15 seconds.
After five seconds the sys tem disarms. If the system does not dis-
arm, you may have waited too long. Turn the ignition off and on
and try again.
Location of Valet Button_________________________________
© 2012 Directed. All rights reserved.
again after resetting the system, disarms the system.
during the first six seconds of the triggered sequence
stops the
11