Set Jumpers; Avoid Static Electricity - American Megatrends Atlas III PCI User Manual

Set Jumpers

Set all jumpers and install the CPU before placing the motherboard in the
chassis. Set jumpers by placing a shunt (shorting bridge) on the designated pins
of the jumper. A shunt and jumpers are shown below:
3-dimensional view of motherboard jumpers and a shunt.
Shunt
3-pin Berg
In this manual, jumpers are shown in two -dimensions,
as if viewed from directly above, as shown below:
The placement of shunts is
indicated by a solid line
1
2
between pins, as shown
between Pins 1-2
3
4 to the right:
6
5

Avoid Static Electricity

Static electricity can damage the motherboard and other computer components.
Keep the motherboard in the anti-static bag until it is to be installed. Wear an
anti-static wrist grounding strap before handling the motherboard. Make sure
you stand on an anti-static mat when handling the motherboard.
Avoid contact with any component or connector on any adapter card, printed
circuit board, or memory module. Handle these components by the mounting
bracket.
Chapter 1 Hardware Installation
2-pin Berg
1
3
5
2
4
6
9