AT&T E5943 User Manual page 54

Appendix Appendix
Troubleshooting
Common cure • If the phone does not seem to be responding normally, try
for electronic
equipment.
• Disconnect the power to the base.
• Disconnect the cordless handset battery, and spare battery, if
• Wait a few minutes.
• Connect power to the base.
• Re-install the battery pack, and place the cordless handset into
• Wait for the cordless handset to re-establish its connection with
Incomplete • If a caller leaves a very long message, part of it may be lost
messages.
• If the caller pauses for more than seven seconds, the system
• If the system's memory becomes full during a message, the sys-
• If the the caller's voice is very soft, the system may stop record-
Difficulty hear-
• Press VOLUME
ing messages.
System does • Make sure that the answering system is on (see page 30).
not answer
• If Toll Saver is activated, the number of rings changes to two
after correct
number of
• In some cases, the system may be affected by the ringing sys-
rings.
• If the memory is full or the system is off, the system will answer
• You need to reset the answering system clock (see page 31).
"CL" flashes
in message
window.
putting the cordless handset in its base. If it does not seem to
respond, do the following (in the order listed):
applicable.
the base.
the base. To be safe, allow up to one minute for this to take
place.
when the system disconnects the call after four minutes.
stops recording and disconnects the call.
tem stops recording and disconnects the call.
ing and disconnects the call.
^
to increase speaker volume.
when you have new messages waiting (see page 34).
tem used by the local telephone company.
after 10 rings.
50 50