Configuring Wi-Fi Protected Setup Manually - Lexmark S415 Quick Reference Manual

Wireless networking
You can find these WPS logos on the side, back, or top of your access point.
For more information on accessing the wireless settings and determining the WPS capability of your access
point, see the documentation that came with the access point or contact your system support person.
Configuring Wi‑Fi Protected Setup manually
Note: Make sure your access point (wireless router) is Wi‑Fi Protected Setup (WPS) certified. For more
information, see the User's Guide.
If your printer or device has not yet been configured for wireless connection and you want to configure
it using WPS, then push the WPS button on the wireless router. Wait for the printer control panel to display
a message to begin WPS configuration. There might be a short delay before the message appears. If nothing
happens after 30 seconds, then do one of the following:
U P B C
SE THE USH UTTON ONFIGURATION
1
From the printer control panel, navigate to:
> Setup > OK > Network Setup > OK
Setup > OK > Wireless > OK > Wi‑Fi Protected Setup >
2
Follow the instructions on the printer display.
U P I N
SE THE ERSONAL DENTIFICATION
1 From the printer control panel, navigate to:
> Setup > > Network Setup >
OK OK
Setup > > Wireless > > Wi‑Fi Protected Setup >
OK OK
2
Follow the instructions on the printer display.
(PBC)
METHOD
> Wireless 802.11b/g/n > OK > Network Connection
OK > WPS PBC Mode > OK
(PIN)
UMBER METHOD
> Wireless 802.11b/g/n > > Network Connection
OK
> WPS PIN Mode >
OK OK
42