Dell PowerEdge 6600 Installation Manual page 4

Adding or Replacing a Microprocessor
CAUTION: Before you perform this procedure, you must turn off the system and
disconnect it from its power source.
NOTICE: See "Protecting Against Electrostatic Discharge" in the safety instructions in your
System Information document.
NOTE: For steps 1 through 5, see your Installation and Troubleshooting Guide for
details.
Open the bezel.
1
Turn off the system, including any attached peripherals, and disconnect the system
2
from the electrical outlet.
Remove the back cover.
3
Remove the front cover.
4
Raise the following components to the service position:
5
•
•
•
While grasping the microprocessor tray handles, press the release levers with your
6
thumbs and rotate the tray handles up until the tray is released from the front panel
(see Figure 1-1).
Slide the microprocessor tray out until the safety latches lock into place.
7
While pressing on the safety latches, pull the microprocessor tray straight out until the
8
tray clears the chassis.
Place the microprocessor tray on a flat surface.
9
While holding the tab on the side release lever, rotate the lever up until the cover is
10
released from the side of the enclosure (see Figure 1-1).
While holding the front release lever, rotate the lever up until the cover is released
11
from the front of the enclosure (see Figure 1-1).
Remove the cover.
12
1-2
M i r c r o p r o c e s s o r U p g r a d e In st alla tion G uid e
Memory riser cards
Peripheral riser card
Fans