Advertisement
17
Loosen the two thumbscrews securing the riser board and disconnect it from the system
board card-edge connector. See "Removing the Riser Board" in your Installation and
Troubleshooting Guide.
18
Slide the backplane securing latch forward to the open position to allow the system
board/backplane board to move to the forward (unlatched) position.
19
Slide the system board/backplane board assembly forward, toward the front of the system and
lift the assembly up and out of the chassis. See Figure 1-1.
Figure 1-1. Removing the System Board/Backplane Board Assembly
backplane release latches (2)
20
Lay the system board/backplane board assembly down on a smooth, nonconductive work
surface.
21
Remove the three Phillip screws that secure the system board to the backplane board. See
Figure 1-2.
4
Replacing the System and Backplane Board Assemblies
thumbscrew
backplane securing latch
Advertisement
