F i g u r e 1 - 4 .
Installing the RapidRails Slide Assemblies
At the front of the rack cabinet, position one of the RapidRails slide assemblies so that
1
its mounting-bracket flange fits between the marks or tape you placed on the rack (see
Figure 1-5).
The top mounting hook on the slide assembly's front mounting bracket flange should
enter the top hole between the marks you made on the vertical rails.
Push the slide assembly forward until the top mounting hook enters the top square
2
hole that you placed a mark just above on the vertical rail, and then push down on the
mounting-bracket flange until the mounting hooks seat in the square holes and the
push button pops out and clicks (see Figure 1-5).
1-8
Rack Installation Guide
M a r k i n g t h e V e r t i c a l R a i l s
tape on
vertical rail