Sharp PG-M20S - Notevision SVGA DLP Projector Operation Manual page 33

3
Press , or
mote control to select the IN-
PUT Mode.
After pressing
ton to select the desired INPUT Mode.
Note
When no signal is received, "NO
SIGNAL" will be displayed. When a
signal that the projector is not pre-
set to receive is received, "NOT
REG." will be displayed.
About the INPUT Modes
INPUT 1 Used for projecting im-
(RGB/ ages from equipment that
Component) sends RGB signals or
Component signals con-
nected to the DVI-DIGI-
TAL/ANALOG input port.
INPUT 2 Used for projecting im-
(S-Video) ages from equipment
connected to the S-
VIDEO input terminal.
INPUT 3 Used for projecting im-
(Video) ages from equipment
connected to the VIDEO
input terminal.
4
Press or
control to adjust the volume of
the speaker.
Note
Pressing will raise the volume.
Pressing will lower the volume.
On the projector, the volume can be
adjusted by pressing
, on the projector operate
as cursor buttons (
selecting setup or adjustment
functions while adjusting menus or
the lens.
on the re-
once, use the but-
on the remote
or .
, ) when
"On-screen Display (Example)
INPUT 1 Mode
Using
DVI digital
Using Analog
RGB
Using
Component
INPUT 2 Mode
Using S-Video
INPUT 3 Mode
Using Video
VOLUME
buttons
-29