Unix; Overview; Configuration; Network Interface Card Setting - Oki B4300 User Manual

UNIX

Overview

The OkiLAN print server supports many protocols such as LPD, FTP,
TELNET, SNMP and IPP, and works within the UNIX environment.
To use the network card within the UNIX environment, the following
steps are required:

Configuration

Network Interface card setting

The first step in installing the network card under UNIX is to set up the IP
address, Subnet Mask and Gateway. This section explains one way to set
them up from a UNIX workstation.
> The network addresses used in this manual are shown as examples
only. Network addresses used in your installation must be generated
for your own network.
> Log in as [root] to change the configuration of the Print Server. By
default, there is no root password.
> If an incorrect IP address, Subnet Mask or Gateway is entered, the
network may go down or other damage may occur. Check the
address with your network manager.
The following explanation uses Sun Solaris 2.8 (Solaris 8) as an example.
The actual commands may differ between versions of UNIX, so refer to
the workstation manuals for more information.
1. Log in as root to the workstation
> If you do not have superuser rights, the network manger should
conduct the configuration.
2. If the print server does not have an IP addresses already assigned,
use the arp command to set a temporary IP address.
Example: for IP address 192.68.20.127 and network card address
00:80:92:01:00:D2
UNIX 91