Konica Minolta magicolor 1600W User Manual page 30

(Refer to "Replacing a Toner Cartridge" on page 5-5.)
(Refer to "Removing All Toner Cartridges" on page 5-11.)
P/H Clean Up—Click the button to switch the printer to the P/H Clean
Up mode.
Print Head Cleanup mode is a mode that allows the user to clean the
print head window more easily. The print head window is not cleaned
automatically.
(Refer to "Cleaning the Print Head Window" on page 6-8.)
Set Default
When the Remote Panel Utility is started up again after it has been
exited using the icon in the Windows notification area (right end of the
taskbar), the default settings will be displayed. To view the actual set-
tings, click the Display Configuration Page button.
Apply—Click to send the settings specified for "Toner Low Message",
"Toner Out Stop", "Energy Save Time" and "Auto Continue" to the
printer.
Toner Low Message—Specifies whether a printer indicator blinks or a
warning message appears in the status display box of the Remote
Panel Utility when toner is about to run out. If Off is selected, neither
of these notifications appear when the toner is about to run out.
Toner Out Stop—Specifies whether or not printing stops when the
toner becomes empty.
If Off is selected, printing can continue even if toner has run out.
However, the printing results are not guaranteed. If printing is contin-
ued, the Error indicator (orange) lights up and printing stops.
Energy Save Time—Set time to enter Energy Save mode when no
operation is performed.
Working with the Remote Panel Utility
Change Toner:
Eject All Toner:
The printer can also be switched to any of these operation modes
by pressing the Rotate Toner key on the printer.
Refer to "About the Rotate Toner KEY" on page 1-6.
Used when replacing a toner cartridge.
Select this mode, and then click the Rotate
Toner button to switch the printer to the Change
Toner mode.
Used when removing all toner cartridges.
Select this mode, and then click the Rotate
Toner button to switch the printer to the Eject All
Toner mode.
3-3