Canon 2921B002 On-Screen Manual page 636

Bluetooth Settings Screen
OFF or Disable (Default setting)
Enables searching and printing from a Bluetooth device.
Security Screen
Enable
Selecting Enable allows you to choose either of the security modes below.
Mode 3(recommended)
This mode is activated on link level enforced security.
The passkey will be required when a Bluetooth device communicates with the printer.
Normally select this mode.
Mode 2
This mode is activated on service level enforced security.
The passkey will be required when printing through the Bluetooth communication.
After setting the security mode, we recommend making a trial print through Bluetooth
communication. If printing does not start, change the security mode and try again.
Disable (Default setting)
When you register the printer, you are not required to input a passkey.
Setting a passkey will prevent unwanted access from other Bluetooth devices. You can
change the passkey on the Passkey screen.
Passkey Screen
When you select Enable on the Security screen, you are required to set a passkey to register the
printer on other Bluetooth devices.
After you change the passkey, you may be asked to input the passkey on the Bluetooth devices you
were able to print from before the passkey was changed. In this case, input the new passkey.
Page 636 of 815 pages
Page top