Frigidaire PLBMV188HC - Microwave Use & Care Manual page 26

CHARCOAL FILTERS
Charcoal Filters, which are attached with Hood Louver, are
used for nonvented, recirculated installation. The filter should
be changed every 6 to 12 months depending on use.
1. Disconnect power to the microwave oven at the circuit
breaker panel or by unplugging.
2. Remove three Houver Louver Screws.
3. Push the upper tabs and pull the louver away from the
unit.
4. Remove the charcoal filters from hood louver and replace
new charcoal filters by piercing tabs into the holes in char-
coal filters.
5. Carefully push the louver back into place and replace the
screws removed at step 2.
Oven Light Cover
Hood Louver
Screws
Hood Louver
Figure 1
Inside of Hood Louver
Tabs
Figure 2
E
CLEANING AND CARE
Disconnect the power cord before cleaning or
leave the door open to deactivate the oven during cleaning.
Upper Tab
Bottom Tab
Charcoal Filters
MICROWAVE OVEN LIGHT
Remove the louver per instructions 1-3 above, if used.
1. To replace an old light bulb, first disconnect power to the
microwave oven at the circuit breaker panel or by unplug-
ging.
2. Open oven light cover by carefully pulling up on the front
edge. See figure 1.
3. Remove an old light bulb and replace a new 20 watts light
bulb. DO NOT USE BULB LARGER THAN 20 WATTS.
4. Close the Oven Light Cover by carefully pushing into place.
Push the louver back into place (engaging both the bottom
and top tabs) and replace three Houver Louver Screws.
WORK/NIGHT LIGHT
1. To replace old light bulbs, first disconnect power to the
microwave oven at the circuit breaker panel or by unplug-
ging.
2. To open Light Cover, remove the screw on the light cover.
(See Figure 3.)
3. Replace the old light bulbs with new bulbs. DO NOT USE
BULBS LARGER THAN 20 WATTS.
4. Close the Light Cover and secure with screw removed at
step 2.
BOTTOM VIEW
Light Cover
Figure 3
Light Cover may become very hot. Do not press
glass when light is on.
26
(Front of microwave oven)
Light Bulbs
(Rear of microwave oven)
Screw