Whirlpool AMD 017 Manual page 17

IMPORTANT:
Piping Joints Thermal Insulation:
Wrap the piping joints with thermal insulating materials and then wrap with a vinyl tape.
Thermal insulation
Thermal Insulation piping:
a. Place the drain hose under the piping.
b. Insulation material: polythene foam over 6mm in
thickness.
NOTE: Drain hose is prepared by user.
• Drain pipe should point downward for easy drain
flow.
Do not twist the drain pipe, leave it sticking out or
waving around, do not immerse the end in water.
If an extension drain hose is connected to the drain
pipe, make sure to be thermally insulated when
passing it through the indoor unit.
• When the piping is directed to the right, piping,
power cord and drain pipe should be thermally
insulated and fixed at the rear of the unit with a
piping fixer.
Base
A. Insert the pipe fixer to the slot.
B. Press to hook the pipe fixer onto the base.
Piping fixer
Base
Wrapped with vinyl type
Large pipe
Power cord
Power cord 1
(for heat-pump)
Defrost cable
(for heat-pump)
Insert here
Large
pipe
Drain
Small
hose
pipe
Piping fixer
20
Thermally
insulated tube
Small pipe
Drain hose
(prepared by user)
Large
pipe
Drain
Small
hose
pipe
Hook here
Base