DISPLAYED MESSAGES
DISPLAYED MESSAGE
(alternating with)
(and then)
(alternating with)
POSSIBLE CAUSE
•
The water tank is empty or
incorrectly positioned.
•
The ground is too fine so the
coffee runs off too slowly.
•
The tank was removed during
run-off.
•
There is air in the hydraulic circuit.
•
The coffee grounds container (A4)
is full or more than three days
have passed since the last run-off
(this operation ensures the
machine remains hygienically
clean).
•
After cleaning, the grounds
container has not been replaced.
•
The "pre-ground coffee" function
has been selected without
placing any pre-ground coffee in
the funnel.
•
The funnel (A21) is blocked.
•
Indicates that descaling must be
carried out.
•
Too much coffee has been used.
•
The coffee beans have run out.
•
The brewing unit has not been
replaced after cleaning.
•
The service door is open.
•
The inside of the appliance is very
dirty.
GB39
REMEDY
•
Fill the tank with water and/or insert
it correctly, pushing it as far as it will
go.
•
Turn the grinding adjustment knob
one click towards number 7.
•
Replace the tank and press OK (B7).
The display shows
machine runs off hot water and is
then ready for use again.
•
Empty and clean the grounds
container, then replace it.
IMPORTANT: when removing the drip
tray, the grounds container MUST be
emptied, even if it is not completely
full. If this is not done, when you
make the next coffees, the grounds
container may fill up more than
expected and clog the machine.
•
Open the service door and insert the
grounds container.
•
Slide the machine out and, using the
funnel, add pre-ground coffee.
•
Carefully use a knife to clear the
funnel as described in paragraph
.
•
The descaling programme must be
carried out as soon as possible,
following instructions described in
paragraph
•
Select a milder taste or reduce the
quantity of ground coffee, then run
off the coffee again.
•
Fill the beans container.
•
Insert the brewing unit as described
in paragraph
.
•
Close the service door.
•
Clean the inside of the appliance
thoroughly, as described in chapter
message is still displayed after
cleaning, contact a service centre.
. The
.
. If the