Operating the cleaner
USING THE ROBOTIC VACUUM CLEANER
ATTACHING A MOP
You can effectively remove dust with the microfiber mop.
Mop attachment procedures
1. Attach the mop to the Velcro fastener of the mop
plate.
- Attach the mop making sure that the mop
attachment line is not covered.
2. Align the holes of the mop plate with the parts
at the bottom of the cleaning robot and push the
parts until they 'click' into place.
- Note that if you install the mop plate incompletely,
it may separate while cleaning.
3. Place the mop plate to which the mop is
attached on the floor and push it down.
●
Since the cleaning robot cannot move over
carpets after attaching a mop, remove the mop
CAUTION
and mop plate from the cleaning robot before
cleaning a carpet.
●
After cleaning, wash the contaminated mop.
●
Use the mop only after completely drying it.
(You cannot use a wet mop.)
●
If there is liquid such as coffee on the floor, do
not use the mop to clean it to prevent secondary
contamination of the floor by the liquid.
Mop attachment
line
✽ Attach the mop making sure it is
level with the mop attachment
line.
Parts to install
Mop plate fixing
the mop plate
holes
Operating the cleaner _27