Removing The Base - NEC AS192WM-BK User Manual

Non-abrasive surface
Figure R.1

Removing the Base

NOTE: Always remove the Base when shipping the LCD.
1. Place monitor face down on a non-abrasive surface (Figure R.1).
2. While using your fingers, press the 3 locking tabs of left or right side
at the same time to unlock the Base.
3. While using your fingers, press the 3 locking tabs of another side
at the same time to unlock the Base.
4. Pull out the unlocked Base.
Connecting a Flexible Arm
This LCD monitor is designed for use with a flexible arm.
Please use screws (4pcs) as shown in the picture when installing. To meet the safety requirements, the monitor must be
mounted to an arm which, guaranties the necessary stability under consideration of the weight of the monitor.
The LCD monitor shall only be used with an approved arm (e.g. GS mark).
NOTE: To meet the safety requirements, the monitor must be mounted to an arm that supports the weight of the monitor
and be UL-certified. See page 11 for details. Remove the stand base before mounting.
Specifications
4-SCREWS (M4)
(MAX depth: 10 mm)
If use other screw,
check depth of hole.
Figure R.2
12 mm
4 x 12 mm with lock washer
and flat washer
Weight of LCD assembly: 3.3 kg (MAX)
English-7
M4
100 mm
100 mm
Figure R.3
Locking tabs
Thickness of Bracket
(Arm) 2.0 ~ 3.2 mm
Tighten all screws