Removing The Base - NEC MultiSync LCD1555V User Manual

Removing the Base

Note: Always remove the Base when shipping the LCD.
1. Place monitor face down on a non-abrasive
surface (Figure R.1).
2. While press the locking tabs downward, pull
the base off the stand.
Connecting a Flexible Arm
This LCD monitor is designed for use with a flexible arm. Please use the attached
screws (4pcs) as shown in the picture when installing.
To meet the safety requirements, the monitor must be mounted to an arm which
guaranties the necessary stability under consideration of the weight of the monitor.
The LCD monitor should only be used with an approved arm (e.g. GS mark).
Specifications
4-SCREWS (4M)
(MAX depth: 8.5mm)
If using other screws,
check depth of hole.
LCD1555V110502.p65
–continued
Weight of LCD assembly: 2.7kg (MAX)
6
6
Thickness of Bracket (Arm)
2.0~3.2mm
Tighten all
screws.
11/20/02, 8:49 AM