Using The Wireless Audio Set; Powering On Your Equipment - Epson MovieMate 30s Quick Manual

Using the Wireless Audio Set

Powering On Your Equipment

1. Push the P button on the transmitter. The P light turns solid green.
2. Push the P button on the receiver. The P light turns solid green.
3. Make sure that the
Note:
If the LINK lights are not solid green, there is no connection between the
transmitter and receiver. Make sure that there is direct line of sight between
the two antennas and that the transmitter and receiver are less than 19.7 feet
(6 meters) apart. If the LINK lights are still not solid green, see "Solving Problems"
on page 21.
4. Turn on your Epson MovieMate or DVD player.
5. Turn on your audio system. You're ready to start watching a movie.
Note:
If the transmitter doesn't receive an audio signal for more than 5 minutes, it will
automatically go into standby mode. If it still hasn't received an audio signal after
25 minutes, it will turn off automatically. Press the P button to turn it back on again.
If you don't have any audio output, make sure that the volume control on your
audio system is not turned all the way down or muted; see "Controlling Volume"
on page 20. If you still don't hear any audio, see "Solving Problems" on page 21.
light on the transmitter and receiver is solid green.
LINK
Using the Wireless Audio Set
19