Epson MovieMate 30s Quick Manual page 16

Connecting to Unpowered Speakers
The receiver includes a built-in 15-watt amplifier that allows you to power two
6 ohm unpowered speakers. Before you begin, make sure that the receiver is
turned off and the volume control is turned all the way down.
Caution:
Do not connect more than two speakers or speakers with an impedance rating lower
than 6 ohms to the receiver or you may damage the receiver and your speakers.
Warning:
Make sure that the receiver is turned off and the volume control is turned all the way
down before you connect the speakers or you may damage them.
Connect your speakers to the receiver as shown below.
When you're finished connecting the speakers, do one of the following:
■
If you connected the transmitter to an Epson MovieMate, see page 17.
■
If you connected the transmitter to a DVD player, see page 18.
16
Setting Up
R L