Table of Contents
Advertisement
GAS CONNECTION
1. Remove the shipping cap from gas pipe at the rear of
the dryer.
NOTE; DO NOT connect the dryer to L.R gas service
without converting the gas valve. An LR
conversion kit must be installed by a qualified gas
technician.
Connecta
/2 inch (1,27cm) I.D. semi-rigid or approved
pipe from gas supply line to the 3/8 inch (0,96 cm) pipe
located on tile back of tile dryer (see pages 6 and 7),
Use a 1/2 inch to 3/8 inch (!,27 cm to 0.96 cm) reducer
for a connection. Apply an approved thread sealer that
is resistant to the corrosive action of liquefied gases on
all pipe connections.
3. Open tile shutoff valve in the gas supply line to allow
gas to flow through pipe.
VALVE
OPEN / GAS FLOW
POSITtON
.
Test all connections
by brushing
on a soapy water
solution.
NEVER test for gas leaks
with
an open
flame.
GENERAL
INSTALLATION
1. Connect the exhaust duct to outside exhaust system
(see pages 3 and 4), Use duct tape to seal all joints.
2. With the dryer in its final position, adjust one or more of
the legs until the dryer is resting solid on all four legs.
Place a level on top of the dryer. The dryer MUSTbe
level and resting solid on all four legs.
3. Plug the power cord into a grounded outlet. NOTE:
Check to ensure the power is off at circuit breaker/fuse
box before plugging the power cord into tile outlet.
4. Turn on the power at the circuit breaker/fuse box.
Before
operating
the dryer,
make sure the
dryer
area is clear and free from
combustible
materials,
gasoline,
and other
flammable
vapors.
Also see that
nothing
(such as boxes,
clothing,
etc.) obstructs
the
flow
of combustion
and ventilation
air.
5. Run the dryer through a cycle check for proper
operation.
NOTE: On gas dryers, before the burner will light, it is
necessary for the gas line to be bled of air. If the
burner does not light within 45 seconds the first
time the dryer is turned on, the safety switch will
shut the burner oft. If this happens, turn the timer
to "OFF" and wait 5 minutes before making another
attempt to light.
6. If your dryer does not operate, please review the "'Avoid
Service Checklist"' located in your Use and Care Guide
before calling for service.
7. Place these instructions in a location near the dryer for
future reference.
NOTE: A wiring diagram is located inside the dryer
console or under the top panel.
REPLACEMENT
PARTS
If replacements parts are needed for your dryer, contact the
source where you purchased your dryer, call 1-800-944-9044,
or visit our website, www.frigidaire.com,
for the Frigidaire
Company Authorized Parts Distributor nearest you.
Label all wires prior to disconnection when
servicing controls. Wiring errors can cause improper and
dangerous operation. Verify proper operation after servicing.
Destroy tile carton and plastic: bags after
the dryer is unpacked. Children might use them for play.
Cartons covered with rugs, bedspreads, or plastic sheets
can become airtight chambers causing suffocation.
Place
all materials in a garbage container or make materials
inaccessible to children.
The instructions in this manual and all other
literature included with this dryer are not meant to cover
every possible condition and situation that may occur.
Good safe practice and caution MUST be applied when
installing, operating and maintaining any appliance.
11
Advertisement
Table of Contents
