Maintenance - Echo EDR-2100 Operator's Manual

Echo operator's manual engine drill edr-2100
Hide thumbs Also See for EDR-2100:
Table of Contents

Advertisement

Air filter
Fuel filter
Cap
0.6 - 0.7 mm ( 0.024 - 0.028 in)

MAINTENANCE

Air cleaner cover
12
AIR FILTER
Clean before Use.
- Remove air cleaner cover and pull out
air fillter.
- Lightly brush off dust or wash it in water
and detergent.
- Dry completely before putting it back in
place.
FUEL FILTER
Check periodically.
- Do not allow dust to enter into fuel tank.
- Clogged filter will cause difficulty in
starting engine or poor engine
parformances.
- Pick up fuel strainer through fuel inlet
port with a piece of steel wire or the like.
- When filter is dirty, replace it.
SPARK PLUG
Check periodically.
- The standard spark gap is 0.6 to 0.7 mm
(0.024 to 0.028 in).
- Correct spark gap if it is wider or narrower
than the standard gap.
- If the electrodes are coated with carbon
deposites replace with a new spark plug.
Do not sandblast to clean.
Remainnig sand will damage engine.
Fastening torque = 14.2 to 15.2 N
IMPORTANT
Do not over tighten plug.
·
m
·
(145 to 155 kgf
cm )

Advertisement

Table of Contents
loading

Table of Contents

Save PDF