Supported Switches - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Administrator's Manual

5. Click OK to save the changes.

Supported switches

You can use EZSwitchSetup with the following switches:
•
•
•
•
•
•
•
Your switch must meet the following requirements:
•
•
•
EZSwitchSetup Administrator's Guide
53-1001193-02
FIGURE 2
Configuring Internet Explorer
Brocade 200E switch
Brocade 300 switch
Brocade 4100 switch
Brocade 4900 switch
Brocade 5000 switch
Brocade 5100 switch
Brocade 5300 switch
It must be connected to an Ethernet LAN that is accessible by the host. If it is not, the system
issues the message "Page not Found."
It must be in a single-switch fabric. If your switch connects to another switch (if there is an
E_Port on the switch), you cannot manage the switch using EZSwitchSetup until you
disconnect the switch connection.
It must be running Fabric OS v6.2.0.
NOTE
If there is an E_Port on the switch and if there is a zone conflict, then the fabric is segmented;
in this case, the switch is in a fabric by itself and EZSwitchSetup treats it as a single-switch
fabric.
Supported switches
Configure your browser to
check for newer versions of
stored pages on every visit to
the page.
1
3