3
Zoning management
Viewing the zone access map
Click View under Zoning in the task panel to view the Zone Access Map for Devices
The HBA and storage device names displayed in the matrix are the alias names of the devices (see
"Assigning and renaming device aliases"
assigned, devices are identified by WWN. When aliases are assigned, you can see the WWN in a
tool tip by hovering the mouse cursor over the alias.
Editing the zoning configuration
You can customize which HBAs can access which storage devices by clicking Edit in the Zoning task
panel. This starts a wizard that creates a new Custom Zoning scheme based on your device
accessibility choices.
If you make any zoning changes to the default Typical Zoning configuration, you will be creating a
Custom Zoning configuration to replace it. You can later restore the Typical Zoning configuration by
clicking Restore Default Typical Zoning in the task panel.
1. Click Edit under Zoning in the task panel.
2. Click Next.
3. Add or modify aliases in the New Alias column.
4. Click Next.
42
FIGURE 41
Zone Access Map
A wizard launches, briefly displaying the Zone Access Map for Devices.
A Configure Ports and Connect Devices screen displays device connections, over the Zone
Access Map for Devices. Check to be sure all connected devices are present and recognized by
the switch.
The Define Device Aliases screen is displayed.
The Edit HBA/Storage Accessibility Matrix is displayed.
on page 39 for additional information). If no aliases are
(Figure
41).
EZSwitchSetup Administrator's Guide
53-1001193-02