Installing A Usb Tape Drive - IBM 7977E7U User Manual

Installing a USB tape drive

To install a USB tape drive, complete the following steps:
1. Read the safety information that begins on page v and "Installation guidelines"
on page 21.
2. Turn off the server and peripheral devices, and disconnect the power cords
and all external cables necessary to replace the device.
3. Unlock and remove the left-side cover (see "Removing the left-side cover" on
page 24).
4. Remove the front fan cage assembly:
a. Press the fan cage release latches on each side of the fan cage toward the
sides of the server. The cage will lift up slightly when the release latches
are fully open.
b. Grasp the cage and lift it out of the server.
5. Press on the bezel retention tab at the center-left-edge of the bezel, and rotate
the left side of the bezel away from the server; then, pull the bezel away from
the server.
6. Slide the drive into the server.
7. Using the supplied screws, secure the drive to the server chassis.
EMC shields
Tape drive
Chapter 2. Installing optional devices
33