Table of Contents
Advertisement
v When you install additional DIMMs, be sure to install them in pairs. All the DIMM
v The memory controller has four fully buffered DIMM channels that are organized
v You do not have to save new configuration information when you install or
v The 12 DIMM connectors are divided between the two memory branches. DIMM
v The server can operate in two major modes: mirroring and non-mirroring
v The server supports memory mirroring (mirroring mode) and online-spare
38
IBM System x3500 Type 7977: User's Guide
pairs must be the same size and type.
into two branches. Each branch has two channels, and each channel controls
two DIMMs. DIMMs that are next to each other (for example, in DIMM connector
1 and DIMM connector 4) within the channels of a branch must be identical in
size, type, speed, and technology. However, the DIMMs in the connectors above
or below each other within the channels of a branch do not have to be identical
(for example, the DIMMs in DIMM connector 1 and DIMM connector 2 do not
have to be identical). The following illustration shows how the memory controller
is organized into branches and channels with two pairs of installed DIMMs.
remove DIMMs.
Branch 0
Channel 1
Channel 0
DIMM 6
DIMM 3
DIMM 5
DIMM 2
DIMM 4
DIMM 1
connectors 1 through 6 are on branch 0, and DIMM connectors 7 through 12 are
on branch 1.
(normal). The server can also operate in a single-channel mode when one DIMM
is installed.
memory.
– Memory mirroring replicates and stores data on DIMMs within two branches
simultaneously. You must enable memory mirroring through the
Configuration/Setup Utility program (see "Using the Configuration/Setup Utility
program" on page 54). To enable memory mirroring in the Configuration/Setup
Utility program, select Devices and I/O Ports → Advanced Chipset Control →
Memory Branch Mode. Use the arrow keys to change the Memory Branch
Mode setting to Mirror; then, save your changes. When you use memory
mirroring, consider the following information:
- The maximum available memory is reduced to 16 GB, instead of the 32 GB
available in non-mirroring mode.
- The minimum memory configuration is four identical DIMMs. You must
install identical pairs of fully buffered, dual-inline memory modules (DIMMs)
in all four DIMM connectors (same size, type, speed, and technology).
These DIMMs must span across both branches and all four channels. For
example, when you install the first four DIMMs, you must install two DIMMs
in branch 0 (one in channel 0 and one in channel 1) and two DIMMs in
branch 1 (one in channel 2 and one in channel 3). See Table 3 on page 39
for the DIMM installation sequence.
- When you upgrade the server to eight DIMMs, the DIMMs that are next to
each other (for example, DIMM connector 1 and DIMM connector 4) within
the channels of a branch must be identical in size, type, speed, and
technology. However, the DIMMs in the connectors above or below each
Branch 1
DIMM 12
DIMM 9
DIMM 11
DIMM 8
DIMM 10
DIMM 7
Channel 3
Channel 4
Advertisement
Table of Contents
