Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference Manual page 535

Refer to the Fabric OS Command Reference and the snmpMibCapSet command on how to enable
or disable the sending of traps from the various MIBs.
The swSsn variable is optional in trap messages.
The swGroupName, swGroupType, and swGroupMemPos variables are optional trap messages in
v2.6.x. The swGroupName, swGroupType, and swGroupMemPos variables are not supported in
Fabric OS v4.x and above.
Because FOS releases prior to v5.2.0 used to show the Enterprise Field in the swTraps from the
sysObjectID (set using config varaible "snmp.sysObjectID"), the Enterprise field will not always be
resolved to "sw". If the sysObjectID is changed by user the Enterprise field in the trap will show
some unresolved value.
To resolve this issue, beginning with the v5.2.0 release the SNMP configuration variable
snmp.trapEnterpriseFlag lets you define the way that the Enterprise field appears.
Select either the previous behavior in which the Enterprise field is taken from sysObjectID or the
new behavior in which the value in the Enterprise field will alway be "sw".
•
•
Fabric OS MIB Reference
53-1000602-02
Set the value of this variable to 0, to use the sysObjectID .
Set the value to 1 to use the fixed enterprise value, "sw" (1.3.6.1.4.1.1588.2.1.1.1.) .
5
sw Traps
519