Additional Features; Timer-To-Close; Auto Open Jumper; Heater - Chamberlain Elite RSW12V Installation Manual

ADDITIONAL FEATURES

TIMER-TO-CLOSE (TTC)
The TIMER-TO-CLOSE feature can be set to automatically close the gate after a
specified time period. The TTC is factory set to OFF.
If the TTC is set to the OFF position, then the gate will remain open until the operator
receives another command from a remote control or the SINGLE BUTTON control.
TO SET THE TIMER-TO-CLOSE
1
Rotate the TIMER-TO-CLOSE dial to the desired setting. The range is 0 to 180
seconds, 0 seconds is OFF.
NOTE: Any remote control or SINGLE BUTTON command on the control board prior
to the TTC expiring will close the gate. The TTC is reset by any signals from the loops,
close edges and close photoelectric sensors.

AUTO OPEN JUMPER

The factory default position is OFF. If the AUTO OPEN jumper is moved to the "ON"
position, when the operator reaches a low battery voltage threshold (11.5 Vdc) it will
automatically open the gate and hold it in the open position. When the operator
reaches normal battery voltage (12 Vdc or above) the operator will close the gate
when a command is given by either a remote control or the SINGLE BUTTON.

HEATER

The operator may have a heater installed, depending on the model purchased. The
heater must be powered by 120 Vac ONLY. If the heater switch is left in the "ON"
position, the heater will turn on and off automatically when needed.

PARTY MODE

If the Timer-to-Close feature is enabled and you would like the gate to remain open,
open the gate fully, then press the reset button. The next command given by a
LiftMaster remote control or SINGLE BUTTON on the control board will close the gate
and return the operator to normal operation.
NOTE: If an alternative radio receiver is wired to the operator, the receiver must
be wired to the SINGLE BUTTON and CTRL PWR inputs. Refer to page 24.
» TIMER-TO-CLOSE + AUTO OPEN JUMPER + HEATER + PARTY MODE
25
TIMER TO
CLOSE
1
OFF MAX
1