D-Link DGS-3100-48 User Manual page 245

DGS-3100 Series Gigabit Stackable Managed Switch User Manual
ID SEVERITY
Information
SYSLG1.3.2 al
Information
SYSLG1.5.23 al
Information
SYSLG1.5.24 al
Information
SYSLG1.5.25 al
Information
SYSLG1.5.26 al
Information
SYSLG1.5.28 al
Information
SYSLG1.5.29 al
Information
SYSLG1.5.30 al
Information
SYSLG1.6.11 al
Information
SYSLG1.6.8 al
Information
SYSLG4.10.13 al
Information
SYSLG4.15.16 al
Information
SYSLG4.15.18 al
Information
SYSLG4.18.2 al
Information
SYSLG4.6.9 al
Information
SYSLG5.3.11 al
SYSLG6.0.2
Information
229
CATEGORY MESSAGE
threshold.@
PSE power usage %(1)d
in unit %(2)d is below the
System threshold.@
Unit %(1)d was shutdown
- JUMBO frames not
Interface supported.
Master switchover: unit
Stack %(1)d is now master.
Backup master unit %(1)d
was removed from the
Stack stack.
Unit %(1)d was removed
Stack from the stack.
Ipc connection with unit
IP %(1)d failed.
Configuration changed:
%(1)s
Stack cable %(1)s : link
Stack %(2)s on unit-%(3)d
PS# %(1)d status changed
- %(2)s.
FAN# %(1)d status
System changed - %(2)s.
Add dynamic MAC
%(1)m - Vlan %(2)d
failed, %(3)d mac failed to
be inserted from the last
trap
%(1)s %(2)s port %(3)s
Media changed from
%(1)s to %(2)s on port
Interface %(3)s.
Shaper cannot be applied
on port %(1)s since it's
working in half duplex. It
will be applied when the
port changes to full
Security duplex.@
%(1)s of port %(3)j differ
from %(1)s of %(4)j
Activating service
%(1)d...
Up/Download
Boot image download
DESCRIPTION
threshold.
The PSE power used by the
specified unit is below the
threshold.
The specified unit is
shutdown because Jumbo
frames are not supported.
The specified unit is now
the Master unit.
The specified backup
master is removed from the
stack.
The specified unit is
removed from the stack.
The IPC connection with
the specified unit has failed.
The specified stacking cable
is connected to the specified
unit.
The system uses two power
supply sources: #1 and #2.
The system can operate
with one or both power
supply units. The power
supply has changed.
The specified fan status has
changed.
There has been a media
change on the specified
port.
Shaper cannot be applied on
the specified port because it
is working in half duplex. It
will be applied when the
port changes to full duplex.
The system supports the