Defining Stacking Units - D-Link DGS-3100-48 User Manual

DGS-3100 Series Gigabit Stackable Managed Switch User Manual
1. On the Startup menu, press "2".
The following prompt is displayed:
2. Press Enter to apply changes.

Defining Stacking Units

Use the Stack menu option to display the current stack unit ID list and define an alternative unit ID (stack membership
number). Unit ID 0 is allocated for auto-numbering, which is the factory default. Refer to Managing Stacking for further
reference.
To access the stack menu:
1. On the Startup menu, press "3".
The following prompt is displayed:
2. To display the current unit stack ID list, press "1".
The following prompt is displayed:
3. To change the unit ID (stack membership number), press "2".
The following prompt is displayed:
3
Set new device Baud rate: _
Stack menu
[1] Show unit stack id
[2] Set unit stack id
[3] Back
Enter your choice or press 'ESC' to exit:
Stack menu
[1] Show unit stack id
[2] Set unit stack id
[3] Back
Enter your choice or press 'ESC' to exit:
Current working mode is stacking.
Unit stack id set to 0.
===== Press Enter to Continue ====
Stack menu
[1] Show unit stack id
[2] Set unit stack id
[3] Back
Enter your choice or press 'ESC' to exit:
Enter unit stack id [0-6]: