D-Link DGS-3100-48 User Manual page 123

DGS-3100 Series Gigabit Stackable Managed Switch User Manual
The LLDP Port Setting Page contains the following fields:
Field
Unit
From Port
To Port
Notification
Admin Status
Subtype
Action
Address
2. Define the Unit, From Port, To Port, Notification, Admin Status, Subtype, Action and Address fields.
3. Click
107
Figure 0–29. LLDP Port Setting Page
Description
Indicates the stacking member for which the LLDP port settings are defined.
Defines the first port in a consecutive sequence of ports.
Defines last port in a consecutive sequence of ports.
Specifies whether notification is sent when an LLDP topology change occurs on the
port. The possible field values are:
Enabled — Enables LLDP notification on the port.
Disabled — Disables LLDP notification on the port. This is the default.
Specifies the LLDP transmission mode on the port. The possible field values are:
TX — Enables transmitting LLDP packets only.
RX — Enables receiving LLDP packets only.
TX and RX — Enables transmitting and receiving LLDP packets. This is the
default.
Disabled — Disables LLDP on the port.
Defines the address subtype. For example, Always IPv4.
Specifies whether the management address is advertised from the port. The possible
field values are:
Enabled — Enables advertisement from the port. This is the default.
Disabled — Disables advertisement from the port.
Defines the management address advertised from the interface. It is always the
Switch's management address.
. The LLDP port settings are defined, and the device is updated.