Table of Contents
Advertisement
• If you are replacing a memory module, open the retaining clips and remove the old memory module
that is currently installed.
Figure 12. Removing the memory module
• If you are installing a memory module, open the retaining clips of the memory slot into which you
want to install the memory module.
Figure 13. Opening the retaining clips of the memory slot
7. Position the new memory module over the memory slot. Make sure that the notch
module is aligned with the key
into the memory slot until the retaining clips close and the new memory module snaps into position.
2
in the memory slot. Then, press the new memory module straight down
.
Chapter 8
Replacing FRUs (Machine Types: 0864, 7099, and 7846.)
1
on the new memory
77
Advertisement
Table of Contents
