D-Link DCS-3220 - SECURICAM Network Camera Product Manual page 54

Using the DCS-3220 with an Internet browser
(continued)
Configuration > Tools > Applications (Continued)
Weekly schedule:
Sunday through Saturday -
Snapshots begin at -
Snapshots stop at -
All of the time except for
the above schedule -
Snapshot Interval -
Event operation
Delay second(s) before
detecting next event -
Trigger condition -
Select the weekdays that should perform the
following operations:
Set the time to start operations. Setting the begin
time the same as the stop time will force the
operations to run continuously.
Sets the time to stop the operations.
If you do not wish to set a schedule, this box must
be checked.
Interval of time between each sequential
snapshot.
Sets the time delay before restarting to check the
trigger condition when the current condition is
triggered.
There are 4 conditions related to the digital input
and three windows for motion detection. There
can be multiple selections. Select the appropriate
digital input condition according to the
characteristics of the external device. "High", "low"
indicate external voltage input for level trigger,
while "rising", "falling" is for edge triggers. There
are three windows shown for the names you
defined for motion detection. "Undefined" will
show instead of the window title if motion detection
is not setup yet. An active, named motion window
must be checked for motion detection to be
possible.
54