D-Link DCS-3220 - SECURICAM Network Camera Product Manual page 101

Using IP surveillance Software (continued)
Scheduling (continued)
Apply and Erase Buttons
After you have selected the time period with "Begin time" and "End time" picker,
you can apply the period picker, shown in the figure below, to set the periodical
types of the time interval set previously. After the settings in "Begin Time", "End
Time" and "Period Picker" are all done, you should click the "Apply" button or
"Erase" button to add or clear this scheduling information to the editing schedule
scheme. Note that only after you click on the "Apply" button, the scheduling
information settings will be written back into the whole editing schedule scheme.
That means this edited scheduling time interval is valid only after you "Apply"
the changes.
Period picker
Schedule in event mode
You can select to record in Event mode or Continuous mode by the Schedule
mode selector as shown in the figure below. There are two types of event
recording. Please refer to the following two sections for more information.
Motion Detection
As shown above, you can check the windows that you would like to record
while the motion detection is triggered
Apply
.
101
Erase