Table of Contents
Advertisement
NT loudspeakers are designed to meet the requirements and demands of portable
applications as well as permanent installations. The integral electronics are based on proven,
high efficiency amplifier technology, with field-replaceable amplifier modules. The
loudspeakers need to be connected to an ac mains supply and a line level audio signal. The
internal DSP is factory preset to provide correct and consistent performance.
4 . 2 . 1
The 2-way NT loudspeakers are available in both 12-inch and 15-inch LF driver formats.
Different beamwidths are offered to meet typical coverage requirements in their intended
applications. The trapezoidal design of the enclosures makes them easy to use as a main PA
loudspeaker or as a floor wedge for stage monitor applications.
A companion NT subwoofer is engineered to complement the NT full-range loudspeakers.
It extends the low frequency response of an NT full-range system and increases the output
capabilities at low frequencies. The drivers are installed so one is facing into the enclosure,
but connected with opposite polarity so both cones move in the same direction. At high
output levels each cone "loads" the other in the opposite direction to smooth out any
mechanical asymmetries. The result is significantly reduced distortion.
NT Models:
Full-range
Beamwidths H x V
NT26
NT29
NT56
NT59
Subwoofer
NTS22
4 . 2 . 2
As is true of all professional loudspeaker systems, the performance of the NT Series
loudspeakers depends on amplifiers delivering an adequate supply of clean power. To
maximize performance, the full-range loudspeakers are bi-amplified, meaning the LF and HF
drivers each have their own signal processing and built-in, high-efficiency amplifier. The
subwoofer is dual-amplified, meaning each driver has its own, built-in, high efficiency
amplifier.
Loudspeaker
LF Amplifier
Full-range
Subwoofer
2x 1000 W
Section 5
5 . 1
Read and heed all warnings and safety instructions in the supplied "EAW Loudspeaker
Manual" before using this product. Failure to follow this precaution may result in
equipment damage, personal injury, or death.
NOTE: The CSA (Canadian Standards Association) approval rating does not include any
evaluation of mounting / rigging capabilities.
8
M o d e l s
Nominal
60º x 45º
12 in cone, 3 in voice coil
90º x 45º
12 in cone, 3 in voice coil
60º x 45º
15 in cone, 4 in voice coil
15 in cone, 4 in voice coil
90º x 45º
N/A
2x 12 in cone, 4 in voice coil
A m p l i f i c a t i o n
HF Amplifier
1000 W
500 W
N/A
Physical Installation
M o u n t i n g / R i g g i n g
LF Driver
3 in / 1.4 in exit compression driver
3 in / 1.4 in exit compression driver
3 in / 1.4 in exit compression driver
3 in / 1.4 in exit compression driver
H F Driver
N/A
Hide quick links:
Advertisement
Table of Contents
